:	May 20, 2004

: It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

: Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

:

If the SRS component is to be replaced, the bar code of the new unit must be recorded.

.

Make the SRS system safe.

.

Remove the front door trim panel.

.

Remove the front door side impact sensor.   Disconnect the electrical connector.   Remove the 2 Torx bolts.

.

Install the front door side impact sensor.   Tighten the Torx bolts to 8 Nm (6 lb.ft).   Connect the electrical connector.

.

Install the front door trim panel.